£101.27 exc. tax

Module Power Connectors:

9x Doepfer, 3x Integrator

Power input:

15V AC external power supply 500mA (UK or EU adaptor supplied), 2.1mm DC socket

Width:

84HP

This is a lower cost alternative to the pricey aluminium style cases.

The AS0084 will take any combination of Concussor, A100 or Integrator modules with no problems of gaps or lining up because it does not use tapped strips.

Note: Integrator modules are a little wider than Concussor and A100, so it may not be possible to fill the case with only Integrator modules - the total width may be too wide by say 0.5mm.

The power supply board has 9 Doepfer style connectors and 3 Integrator sockets. A 5V power rail is provided for those modules that require it. It uses an external power suppy of 15VAC. This case uses 15V AC (NOT DC!) Use a minimum of 500mA external power supply (not supplied). We can only supply 230V external adaptors with either UK or Euro plugs.

As the power supply requires AC, it does not matter which way round you fit the connector. If you accidentally use a 15DC power supply, it will not cause any damage (but it won’t work).

The case will generally supply a full set of modules unless there are too many power hungry modules.

The AS0084 case eliminates the use of tapped strips, used in the metal case. This saves a heck of a lot of money, but it does mean you must drill your own mounting holes.

The modules are mounted with self tapping screws into plastic mounting blocks. As plastic is not as strong as metal, these cases are not ideal if you constantly are swapping modules around. Although this can be done many times, the thread in the plastic screw holes can weaken with time with constant screwing and un-screwing.

All that is needed is to position modules in the case, mark the mounting holes, remove modules, drill pilot holes approx 1mm to 2mm diameter, screw modules into position. This is far easier than it sounds, but if it puts you off then pay the full cost for a metal case! (Nearly x2).

Notes: do not over tighten the self tap screws otherwise you will strip the thread in the plastic.