Multiple Inputs/Outputs: 2x 4 parallel connected sockets 1x 8 parallel connected sockets (state when ordering) Size: 4HP

Introduction

This is a device that is a row of jack sockets all wire together in parallel.

It can be provided as two independent rows of 4 if required. If you have an 8 way multiple, you only have to remove the tinned wire link on the PCB to make this 2x 4 way multiples.

Use

The main use of a multiples is to split signals, making it available on more than 1 socket. For example, to make the output of an envelope which only has one output socket, available to lots of inputs. Plug the EG output into the multiple, then the seven multiple sockets will also carry that EG signal.

The multiple is a passive module. It takes no power.

When a signal is split by a passive device such as a multiple, the output signal level will be reduced. This generally will not cause a problem as most modules' inputs are buffered.

A multiple can be used as a simple passive audio mixer, but there may be problems of impedance and level matching. It can also be used in some instances to mix control voltages, but this again depends on the design of the modules. With both audio and CV's it is a case of try and see. If it fails to work as desired, no damage will occur.

Concussor Modular Synthesizer from Analogue Solutions
Tel:+44 1384 35 36 94 Fax:+44 1384 35 36 94
e&oe (c) 8 2000