SH-NZ -  S+H / Noise Inputs: Outputs: Power: SH Clock SH Signal  SH Signal Noise +/- 12V Controls:     Slew Rate Noise Level     Indicators: Size:   SH Clock 6HP

Introduction

2 modules in one:

Sample and Hold and Noise features

The S+H and Noise units are independent so can be used entirely of each other.

Controls

S+H Slew

This adds slew (or portamento) between each changing voltage held by the S+H. So as each voltage is sampled, the changes in old to new voltage level will be smoothed out.

Noise Level

Alters the noise level.

Sockets

S+H In

This is the signal source for the S+H. Normally the noise output would be used for a random output.

S+H Clock In

Each clock or gate pulse will make the S+H sample the input signal then hold it till the next clock signal. Normally a square wave signal would be fed into here, like the LFO-NZ square wave output.

S+H Sig Out

This is the output from the S+H unit.

Noise Out

This is an audio output from the white noise generator. This can be fed into the S+H signal input for random S+H.

Obtaining a stepped random signal (using the Sample and Hold Facility)

To create a stepped random voltage (as indicated on the first position of the LFO wavform switch):

Patch a Square wave LFO output into the S+H Clock input, the Noise output to the S+H Signal input. Turn the Noise level up to about 30-50% (A higher setting causes strange - though not neccessarily - output). The S+H output signal will appear at the S+H Out socket.

Concussor Modular Synthesizer from Analogue Solutions
Tel:+44 1384 35 36 94 Fax:+44 1384 35 36 94
e&oe (c) 8 2003